MRD 3187B - User Manual
Page 37 (245)
9. Use the and buttons to move
the cursor to “Color ref:” then press the
button.
10. Use the and buttons to select
the column to edit and use the and
buttons to change the number of
degrees (-180 – +180), then press the
button to save the selection.
SDI VANC Assignment
To edit the SDI VANC Assignment, use the
following steps.
1. Use the and buttons to move the
cursor to “SDI VANC Assign” then press
the button to display the status screen
for the VANC.
2. Press the button once more to enter
the Edit screen.
Ancillary Data Packets
This controls the embedding of the Ancillary Data Packets (ADP) into the VANC
of the SDI output.
1. Use the and buttons to move
the cursor to the desired type of
Ancillary Data Packet (“EIA-608CC”,
“EIA-708CC”, “TTX S2031M”, “Source
ID”, or “SCTE 127”, “AFD”), then press
the button.
2. Use the and buttons to
choose “Enabled” or “Disabled”, then
press the button to save the
selection.
3. Use the and buttons to select
“Line:” for the ADP and press the
button.
4. Use the and buttons to
change the line number (4 – 15) in
which the ancillary data will be located,
then press the button.
Note: Repeat steps 1-4 above to change EIA-708CC, TTX S2031M, Source ID,
SCTE 127 and AFD.
NTSC Waveforms
To enable NTSC items, use the following steps.
SDI VANC 1-1
ADP
EIA-608CC:Disabled
► Line:9
SDI VANC 1-1
ADP
► EIA-608CC:Disabled
EIA-708CC:Disabled
SD Video 1-1
Video
Genlock Offset
►SDI VANC Assignment
Genlock Offset
Vert:-125 lines
Horiz:-0177 pixels
►Color Ref:-100
To Next Page
Loading...
