MRD 3187B - User Manual
Page 46 (245)
Raster Color
This setting determines the color of the raster that is output by the decoder when
input is lost.
1. Use the and buttons to move
the cursor to “Raster Color:” then
press the button.
2. Use the and buttons to
select the desired raster color (“Black”,
“White”, “Yellow”, “Cyan”, “Green”,
“Magenta”, “Red”, “Blue”), then press
the button to save the selection.
VANC Embedding
This controls the embedding of the Ancillary Data Packets (ADP) into the VANC of
the SDI output.
1. Use the and buttons to move the
cursor to “SDI VANC Assignment”, then
press the button to view the Status
screen.
2. Press the button once more to
display the edit menu.
3. Use the and buttons to move the
cursor to the desired type of Ancillary Data
Packet (“EIA-608CC”, “EIA-708CC”, “TTX
S2031M”, “Source ID”, or “SCTE 127”,
“AFD”), then press the button.
4. Use the and buttons to choose
“Enabled” or “Disabled”, then press the
button to save the selection.
5. Use the and buttons to select
“Line:” for the ADP and press the
button.
6. Use the and buttons to change
the line number (4 – 15) in which the
ancillary data will be located.
Note: Use the above steps 3-6 to embed other components on other lines.
Genlock Offset
The 8705/8705A HD video output card can be Genlocked to a standard “black and
burst” or Tri-level sync signal, applied to the Genlock input on the back panel. The
frame rate of the “black and burst” signal must be the same as the frame rate of the
video output. The “Genlock Reference,” under the
button, must be set to the
type of Genlock signal being used as well. If the Genlock input source is lost, the red
Error LED will illuminate, a Decoder Error will show, and the Error list will show the
error. The video will restore but will not be Genlocked until the Genlock signal is
restored.
SDI VANC 2-1
ADP
EIA-608CC:Disabled
► Line:9
SDI VANC 2-1
ADP
► EIA-608CC:Disabled
Line:9
HD Video 2-1
Video
►SDI VANC Assignment
Genlock Offset
HD Video 2-1
SDI Vid Loss Mode:
Display Raster
►Raster Color:Black
To Next Page
Loading...
