MRD 3187B - User Manual
Page 47 (245)
Note: This mode is only available if the unit is equipped with an 8731A or 8734
decoder as well as the 8705/8705A video output card.
1. Use the
and
buttons to move the
cursor to “Genlock Offset,” then press the
button.
Vertical
1. Use the
and
buttons to move
the cursor to “Vert:” then press the
button.
2. Use the
and
buttons to
select the column to edit and use the
and
buttons to change the
number of lines, then press the
button to save the selection.
Horizontal
1. Use the
and
buttons to move
the cursor to “Horiz:” then press the
button.
2. Use the
and
buttons to
select the column to edit and use the
and
buttons to change the
number of pixels, then press the
button to save the selection.
Note: The maximum amount of offset is determined by the format of the video
set.
Overlay Settings
Overlays provide an easy way to help troubleshoot problems, monitor stream
characteristics, or decode closed captioning.
CAUTION: All overlays will appear on the downstream video.
2. Use the and buttons to move the
cursor to “Overlay”, then press the
button.
HD Video 2-1
SDI VANC Assignment
►Overlay
Small Format Disp
Genlock Offset
Vert:-125 lines
►Horiz:-0177 pixels
Genlock Offset
►Vert:-125 lines
Horiz:-0177 pixels
HD Video 2-1
Video
SDI VANC Assignment
►Genlock Offset
To Next Page
Loading...
