MRD 3187B - User Manual
Page 58 (245)
Note: This menu changes depending on which overlay is set in “Overlay”.
1. Use the and buttons to move
the cursor to “Lang:” then press the
button.
2. Use the and buttons to
select the language from those that
are present, then press the
button to save the selection.
Genlock Offset
The 8706A card can be Genlocked to a standard “black and burst” signal applied to
the Genlock input on the back panel. The frame rate of the “black and burst” signal
must be the same as the frame rate of the video output. The “Genlock Reference,”
under the button, must be set to the type of Genlock signal being used as well. If
the Genlock input source is lost, the red “Error” LED will illuminate on the front panel,
a description of the error will be shown in the “Active Errors” menu under the
button, and an entry will be logged in the event log. The video will restore but will not
be Genlocked until the Genlock signal is restored.
When the “Genlock Reference” is set to an SD source of NTSC or PAL, the “Genlock
Offset” includes a “Color Ref” setting.
Note: This mode is only available if the unit is equipped with an 8731A/8734 decoder
as well as the 8706A video output card.
1. Use the and buttons to move the
cursor to “Genlock Offset,” then press the
button.
Vertical
1. Use the and buttons to move
the cursor to “Vert:” then press the
button.
2. Use the and buttons to select
the column to edit and use the
and buttons to change the
number of lines, then press the
button to save the selection.
Note: The maximum amount of offset is determined by the format of the video
set.
Genlock Offset
►Vert:-125 lines
Horiz:-0177 pixels
Color Ref:-100
Anlg Video 1-1
Overlay
►Genlock Offset
Small Format Disp
Overlay 1
Type:Subtitle
►Lang:------
To Next Page
Loading...
