Sencore MRD 3187B - Page 89

MRD 3187B - User Manual
Page 88 (245)
2. Press the button once more to
display the Edit menu.
3. Use the and buttons to move the
cursor to “EIA-608CC”, then press the
button.
4. Use the and buttons to choose
“Enabled” or “Disabled” then press the
button to save the selection.
5. Use the and buttons to select
“Line:” and press the button.
6. Use the and buttons to change
the line number (9 – 15) in which the
ancillary data will be located.
7. Press the button once more to
display the Edit menu.
8. Use the and buttons to move the
cursor to “EIA-708CC”, then press the
button.
9. Use the and buttons to choose
“Enabled” or “Disabled” then press the
button to save the selection.
10. Use the and buttons to select
“Line:” and press the button.
11. Use the and buttons to change
the line number (9 – 15) in which the
ancillary data will be located.
Composite VBI Assignment
To setup Line 21 Closed Captions on the Composite output of this card use the
following steps:
1. Use the and buttons to move the
cursor to “Cmpst VBI Assignment”, then
press the button.
2. Use the and buttons to move the
cursor to “Line21 CC:”, then press the
button on the selected option.
3. Then use the and buttons to
toggle between “Enabled” and “Disabled”,
then press the button to save
changes.
HD/SD Genlock Offset
The 8712 card can be Genlocked to a standard “black and burst” or Tri-level sync
signal applied to the Genlock input on the back panel. The frame rate of the “black
Cmpst VBI 2-1
NTSC
► Line21 CC:Enabled
SDI Anlg Vid 2-1
►Cmpst VBI Assignment
HD Genlock Offset
SD Genlock Offset
SDI VANC 2-1
Line:9
EIA-608CC:Disabled
► Line:9
SDI VANC 2-1
Line:9
► EIA-708CC:Disabled
Line:9
SDI VANC 2-1
ADP
EIA-608CC:Disabled
► Line:9
SDI VANC 2-1
ADP
► EIA-608CC:Disabled
Line:9