Safety and Standards
2. Safety and Standards
2.1 Safety Symbols
Safety symbols indicate that personal injury or equipment damage is likely to occur if specified
precautions and safe operating practices are not followed. The following safety warning symbols
are used on the drive and documentation.
Table 错误!文档中没有指定样式的文字。-1 Safety Warning Symbols
Prompting caution when operating the equipment.
Prompting the operator to know the current situation, or
the operator needs to take measures to avoid adverse
consequences.
Prompting dangerous voltage.
Indicating any terminal, or protective grounding
electrode terminal, used for connection to the outer
conductor to provide protection in the event of a fault.
The marked object is hot and you should be careful
when touching it.
2.2 Safety Guide
The CDHD2S servo drive is used as a component within the machine system.
Machine manufacturers and integrators must ensure personnel safety and machine system
integrity.
Machine manufacturers and/or integrators must take into account the intended use of the
CDHD2S drive when performing a risk assessment. Based on the results of the assessment,
appropriate security measures must be implemented.
CDHD2S drives must be used in compliance with all applicable safety regulations and directives
and all technical specifications and requirements.
CDHD2S drives use dangerous voltage. They must be properly grounded.
Machine manufacturers and machine owners are responsible for machine operator safety.
The machine owner and machine operator are responsible for ensuring that access to
hazardous areas is prohibited while the machine is energized (unless equipped with
appropriate functional safety mechanisms).
Only qualified personnel should perform installation, operation, service and maintenance
procedures. These qualified personnel must have sufficient technical training and knowledge to
anticipate and identify potential hazards that may arise when using the product, modifying settings,
and operating the mechanical, electrical, and electronic components of the entire machine system.
To Next Page
Loading...
