6. Troubleshooting
6-10
CBM-20A/20Alite
Error
The error display can be cleared by clicking [All Clear] or [Clear (Next error)] in the error
window.
This operation also clears the errors displayed at the solvent delivery module or other
component at which the buzzer sounded when the error occurred.
If [System Protection] is set to [Enable] in the solvent delivery module configuration settings,
solvent delivery may continue after an error occurs. Solvent delivery stops when [All Clear] or
[Clear (Next error)] is pressed.
If an error occurs, the currently executed time program stops, and the operation of
autosamplers and fraction collectors is interrupted. Also, operation according to the operation
level is performed as described in the following table.
System controller
0x2F01 to
0x2F0A
OptLink memory error.
0x2F10 to
0x2F3F
Communication error.
0x4001 Buffering error.
0x4004 Buffering error.
0x8001 System check timeout error has occurred.
0x8002 Confirm startup time.
0x8084
PDA detector cannot accept communication command. (PDA
Detector)
0x80E0
The system which can be registered on the group is 10 in the
maximum.
0x80F0
Connection request received from more than one PDA
detector. (PDA Detector)
0x80F3
Connection cancel because of changing PDA detector's IP
address. (PDA Detector)
0x80F4
Connection cancel because of changing PDA detector's
master system name. (PDA Detector)
0x80F5
Connection cancel because of changing PDA detector's
group name/system name. (PDA Detector)
0x80F7 PDA Detector is too busy. (PDA Detector)
0x8568 Rinse liquid is low. (Autosampler)
Supercritical
controller
0x8B94 BPR cover is open.
0x8BA3
Pump has turned off because the pump head cooling
temperature was not stable or cooling was turned off.
All instruments
(Common error
code)
0x00D0 Invalid value.
0x2F80 Undefined warning.
Instrument Error Code Error Message
To Next Page
