SICK microScan3 Core I/O

6 Mounting
6.1 Safety
Information about the requirements for properly mounting the safety laser scanner, see
"A
ssembly", page 26.
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during mounting, electrical installation, and commissioning.
b
Make sure that the safety laser scanner’s outputs do not affect the machine
during mounting, electrical installation, and commissioning.
DANGER
H
azard due to lack of effectiveness of the protective device
If unsuitable brackets are used or if subjected to excessive vibrations, the device may
become detached or damaged.
Persons or parts of the body to be protected may not be recognized or not recognized in
time in case of non-observance.
b
Only use SICK-approved brackets for mounting.
b
Take appropriate measures for vibration damping if vibration and shock specifica‐
tions exceed the values and test conditions specified in the data sheet, see "Data
sheet", page 142.
DANGER
H
azard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of
non-observance.
b
Do not do repair work on device components.
b
Do not make changes to or manipulate device components.
b
Apart from the procedures described in this document, the device components
must not be opened.
NOTICE
T
he optics cover of the safety laser scanner is an optical component.
b
Do not contaminate or scratch the optics cover during unpacking and mounting.
b
Prevent fingerprints on the optics cover.
NOTE
Mount t
he device in the following order.
6.2 Unpacking
Approach
b
Chec
k the components for completeness and the integrity of all parts.
b
Please contact your respective SICK subsidiary should you have any complaints.
MOUNTING 6
8025870/2020-09-04 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 Core I/O
65
Subject to change without notice