Siemens CU240B-2 - Page 111

Installing
4.6 Installing Control Unit
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
111
Default setting 15: "Process industry"
DO 0: p0730,
DO 1: p0731
AO 0: p0771[0], AO 1: p0771[1] DI 0: r0722.5, …, DI 4: r0722.5 AI 0: r0755[0]
Motorized potentiometer setpoint after ramp-function generator: r1050
Speed setpoint (main setpoint): p1070[0] = 755[0], p1070[1] = 1050
Designation in the BOP-2: Proc
Default setting 17: "2-wire (forw/backw1)"
DO 0: p0730,
DO 1: p0731
AO 0: p0771[0], AO 1: p0771[1] DI 0: r0722.2, …, DI 2: r0722.2 AI 0: r0755[0]
Speed setpoint (main setpoint): p1070[0] = 755[0]
Designation in the BOP-2: 2-wIrE 1