Siemens CU240B-2 - Installing Reactors, Filters and Braking Resistors

Installing
4.3 Installing reactors, filters and braking resistors
Converter with the CU240B-2 and CU240E-2 Control Units
58 Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
4.3
Installing reactors, filters and braking resistors
Installing reactors, filters and braking resistors
The following supplementary components may be required depending on the Power
Modules and the particular application:
● Line reactors
● Filter
● Braking resistors
● Brake Relay
Installing these components is described in the documentation provided.
For frame sizes FSA, FSB and FSC, reactors, filters and braking resistors are available as
base components. You can also install base components next to Power Modules.
For modules of the frame sizes FSA, FSB and FSC, reactors, filters and braking resistors are
available as base components. An overview of the permitted base component combinations
is provided below. You can also install base components next to the Power Module.
Installing base components