Siemens CU240B-2 - Changes in this Manual; Converter with the CU240 B-2 and CU240 E-2 Control Units Operating Instructions, 01;2016, FW V4.7 SP6, A5 E34259001 B AC

Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
5
Changes in this manual
Notable changes since the 04/2015 edition of the manual
New hardware
● New Power Module – PM240-2, FSF
Power Module (Page 31)
New functions in firmware V4.7 SP6
● Evaluation of a PT1000 motor temperature sensor
Motor temperature monitoring using a temperature sensor (Page 265)
● Revision of the thermal motor models: p0612 bit 08, 09 and 12
Protecting the motor by calculating the motor temperature (Page 269)
● Support for 1PC1 induction motors
Supported motor series (Page 49)
● Changing the quick commissioning in the "Standard Drive Control" application class:
The motor data identification is no longer permanently set to p1900 = 12; instead, users
select the appropriate motor data identification.
Factory setting: p1900 = 2.
Standard Drive Control (Page 154)
Standard Drive Control (Page 135)
You can find an overview of all new and modified functions in firmware V4.7 SP6:
New and extended functions (Page 477)
Corrections
● The "Moment of inertia estimator" function has been released for all permitted motors.
Moment of inertia estimator (Page 254)
● It is not permissible that the output of the friction characteristic r3841 is interconnected
with p1511 or with p1513.
Friction characteristic (Page 252)