Siemens CU240B-2 - Transferring the Setting from the Memory Card

Backing up data and series commissioning
7.1 Backing up and transferring settings using a memory card
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
357
7.1.2
Transferring the setting from the memory card
Automatically transferring
Precondition
The inverter power supply has been switched off.
Procedure
Proceed as follows to automatically transfer your settings:
1.
Insert the memory card into
the inverter.
2.
Then switch on th
e inverter
power supply.
If there is valid parameter data on the memory card, then the inverter accepts the data from
the memory card.
Manually transferring
Preconditions
•
The inverter power supply has been switched on.
•
No memory card is inserted in the inverter.