Siemens CU240B-2 - Default Settings of the CU240 B-2 Interfaces

Installing
4.6 Installing Control Unit
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
97
4.6.3.2
Default settings of the CU240B-2 interfaces
Default setting 7: "Fieldbus with data set switchover"
Factory setting for inverters with PROFIBUS interface
DO 0: p0730
AO 0: p0771[0]
DI 0: r0722.0, …, DI 3: r0722.3
Speed setpoint (main setpoint): p1070[0] = 2050[1]
Jog 1 speed setpoint: p1058, factory setting: 150 rpm
Jog 2 speed setpoint: p1059, factory setting: -150 rpm
Designation in the BOP-2: FB cdS
Default setting 9: "Standard I/O with MOP"
DO 0: p0730
AO 0: p0771[0]
DI 0: r0722.0, …, DI 3: r0722.3
Motorized potentiometer setpoint after ramp-function generator: r1050
Speed setpoint (main setpoint): p1070[0] = 1050
Designation in the BOP-2: Std MoP