Siemens CU240B-2 - Page 368

Backing up data and series commissioning
7.3 Saving settings and transferring them using an operator panel
Converter with the CU240B-2 and CU240E-2 Control Units
368 Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
BOP-2 → inverter
Procedure
To transfer the settings to the inverter, proceed as follows:
1.
Go to the menu level “OPTIONS”.
2.
In the "OPTIONS" menu, select "FROM
BOP".
3.
Start data transfer with OK.
4.
Wait until the inverter has written the settings to the memory card.
5.
Switch off the inverter power supply.
6.
Wait until all LEDs on the inverter are dark.
7.
Switch on
the inverter power supply again.
Your settings become effective after switching on.
You have transferred the settings to the inverter.