Siemens MAG 5000 - Page 453

7ML19985QT81 XRS-5 Series Transducers – OPERATION MANUAL Page EN-7
English
Direct Connection
Connect the transducer directly to the Milltronics transceiver via the two conductor shielded
cable.
Coaxial Connection
Connect the transducer to the Siemens Milltronics transceiver via a junction box and RG–62 A/
U coaxial cable. This setup is effective for combined runs up to 365 m (1200 ft).
2-Wire Extension
(for EnviroRanger ERS 500, MultiRanger 100/200, and HydroRanger 200 only)
Note: When connecting to an EnviroRanger ERS 500, a MultiRanger 100/200, or a
HydroRanger 200, the white, black, and shield wires are all connected separately. DO NOT
tie the white and shield wires together.
Note: When connecting to an EnviroRanger ERS 500, a MultiRanger 100/200, and
HydroRanger 200, DO NOT use coaxial cable. See diagram below for proper procedure.
b
l
k
/
h
o
t
w
h
t
/
s
h
l
d
wht
blk
drain/shield
extend cable using RG-62 A/U coax
wht
blk
junction box
drain/shield
extend cable using 18 AWG shielded/twisted pair