Siemens simovert masterdrives

Parameter
Description Data Read/write
U848*
S.32BGear 2 Trig
2848
Trigger input "Set output" of the 32-bit gear
[Function diagram 786c]
Init: 0
Unit: -
Indices: -
Type: L2 ,B
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
- Operation enabled
U849*
S.32BGear 2 Fact
2849
Factors of the 32-bit gear
Index 1: Numerator
Index 2: Denominator
[Function diagram 786c]
index1: 0
Unit: -
Indices: 2
Type: L2 ,K
,K
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
- Operation enabled
U850*
S.BPos POS
2850
Source basic positioning position setpoints
Index1: Position setpoint [LU]
Index2: Position actual value [LU]
Index3: Position setting value [LU]
Index4: Position actual value [LU]
Index5: Checkback signal INPUT [LU]
Index6: Checkback signal INPUT [%] (from V2.1)
Index7: Software limit switch plus [LU]
Index8: Software limit switch minus [LU]
Note: If Index 6 Checkback signal INPUT [%] is
connected, Index5: Checkback signal INPUT [LU] is not
used to evaluate the checkback signals. (Evaluation of
speed during rounding U880 != 0)
In function diagram 789b.1
index1: 875
Unit: -
Indices: 8
Type: L2 ,K
,K
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
U851*
S.BPos V-Max
2851
Source basic positioner V-Max [%]
In function diagram 789a.1
Init: 874
Unit: -
Indices: -
Type: L2 ,K
,K
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
- Operation enabled
U852*
S.BPos A-Max
2852
Source basic positioner A-Max [%]
Index1: Acceleration adjustment
Index2: Deceleration adjustment
In function diagram 789b.3
index1: ~
Unit: -
Indices: 2
Type: L2 ,K
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
- Operation enabled
U853*
S.BPos STW
SETUP
2853
Source basic positioning SETUP
(Setup: position controlled jogging)
Index1: D_FWD_ACT
Index2: D_BWD_ACT
Index3: SETUP
In function diagram 789b.1
index1: 875
Unit: -
Indices: 3
Type: L2 ,B
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
- Operation enabled
U854*
S.BPos STW POS
2854
Source basic positioning POS
Index1: POS enable (V<>0)
Index2: Absolute/relative positioning
In function diagram 789b.1
index1: 872
Unit: -
Indices: 2
Type: L2 ,B
Menus:
- Parameter menu
+ Free blocks
- Upread/free access
Changeable in:
- Ready to switch on
- Operation enabled
240
Siemens AG 6SE7087-6QX70 (Edition AL)
SIMOVERT MASTERDRIVES Compendium Motion Control