Siemens SINAMICS S200 - Page 584

• The device provides overtemperature and overload protection.
• Use copper wires wit
h a permissible temperature of 75 °C for all power cables. You can also
use cables with a higher rated temperature value. It is not permissible to reduce the
conductor cross-section.
Additional requirements relating to CSA compliance:
Maximum height for CSA: 2000m.
Motor overload protection according to UL 61800‑5‑1 Ed.2
For the settings required to activate the motor overload protection according to UL 61800‑5‑1
Ed.2, see Section "Cooling (Page520)".
MOTION-CONNECT connection system
The recommended assignment of motors and cables can be found in Section "Device
combinations (Page52)".
Other assignments are not possible.
The technical parameters of the cables are tailored to the requirements of the motors and
veri󹪝ed by system tests. For detailed information, see Section "Technical data of MOTION-
CONNECT cables (Page573)".
Appendix
A.1UL Markings
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
582 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA