Siemens SINAMICS S200 - Page 615

Description: Sets the input terminal to connect probe 2.
Value: 0: No measuring probe
 211: DI 1 (X132.6)
Index: [0] = Motor encoder
[1] = Reser
ved
[2] = Reserved
Dependency
: See also: p0488, p0490
CAUTION
In order to prevent incorrect measurement values, these parameters may not be written during an active measurement.
Note
DI: Digit
al In
put
If par
ame
t
erization is rejected, check whether the terminal is already being used in p2517 or p2518.
p0490.0...1 Invert measuring probe or equivalent zero mark
S200 PTI Data type: Unsigned32 Visible in: Standar
d display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Can be
changed in the operating
state:
Operation
Par
ameter group: Measuring probe
 Unit: -
 Min:
-
Max:
-
Factory setting:
0000 bin
Description: Setting to invert the digital input signals to connect a measuring probe or an equivalent zero mark.
Bit array: Bit Signal name 1 signal 0 signal 
 00 DI 0 (X132.5) Inverted Not inverted 
 01 DI 1 (X132.6) Inverted Not inverted 
Dependency: See also: p0488, p0489, p0494
Note
The t
erminal must be set as input.
When
the measuring probe or the equivalent zero mark is inverted, this has no e󹪜ect on the status displays of the digital
inputs (r0721, r0722).
DI: Digital Input
p0494[0] Equivalent zero mark input terminal
S200 PTI Data type: Integer16 Visible in: St
andard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Can be
changed in the operating
state:
Operation
Par
ameter group: Motor encoder, Homing
 Unit: -
 Min:
0
Max:
211
Factory setting:
0
Description: Selects the input terminal for connecting an equivalent zero mark (external encoder zero mark).
Value: 0: No equivalent zero mark (evaluation of the encoder zero mark)
 210: DI 0 (X132.5)
 211: DI 1 (X132.6)
Dependency: See also: p0490
Appendix
A.3Parameters
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 613