Siemens SINAMICS S200 - Page 725

 Min:
1
Max:
2147483647
Factory setting:
1
Description: Sets the numerator of the electronic gear ratio for the setpoint pulses.
F
our numerators in t
otal are available. You can select one of the numerators by con󹪝guring the digital input signal
EGEAR.
For detailed information about the calculation of a numerator, refer to the Operating Instructions to calculate.
Index: [0] = Electronic gear numerator 0
[1] = Electronic gear numerator 1
[2] = Electr
onic gear numerator 2
[3] = Electronic gear numerator 3
Dependency: See also: p29271, p29273, c29275, c29276
Note
This setting value is only e󹪜ective
when p29271 = 0.
p29273 Denominator of electronic gear
 Data type: Unsigned32 Visible in: Standar
d display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Can be
changed in the operating
state:
Operation
Par
ameter group: Technology Extensions, Processing
 Unit: -
 Min:
1
Max:
2147483647
Factory setting:
1
Description: Sets the denominator of the electronic gear ratio for the setpoint pulses.
Dependency: See also: p29271, p29272
Note
This setting value is only e󹪜ective when p29271 = 0.
c29275 Electronic gear selection bit 0
 Data type: Unsigned8 Visible in: Extended display 
R
ead permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Parame
ter group: Technology Extensions, Processing
Unit: -
Description: Signal of bit 0 for the electronic gear selection.
c29276 Electronic gear selection bit 1
 Data type: Unsigned8 Visible in: Extended display 
R
ead permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Parame
ter group: Technology Extensions, Processing
Unit: -
Description: Signal of bit 1 for the electronic gear selection.
Appendix
A.3Parameters
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 723