Siemens SINUMERIK 808D ADVANCED Series

Commissioning Manual
228 6FC5397-4EP10-0BA8, 07/2018
5.
Press this softkey to confirm your selection, and the archive information displays on the
screen.
6.
Check the archive information and press
this softkey to start loading the series commission-
ing archive.
Note
Successful loading of the data archive can delete the password. You must set the password again before proceeding. For
more information about setting a password, refer to Section "
Setting the password (Page 122)".
9.2
Setting software limit switch data
Refer to Section "Setting software limit switch data (Page 217)".
9.3
Setting backlash compensation data
Refer to Section "Setting backlash compensation data (Page 218)".
9.4
Setting leadscrew error compensation data
Refer to Section "Setting leadscrew error compensation data (Page 219)".
9.5
Tuning drive performance
Refer to Section "Tuning drive performance (Page 220)".
9.6
Creating startup archives
Refer to Section "Creating prototype machine commissioning archives (Page 224)".