Siemens SINUMERIK 808D ADVANCED Series

Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
451
A.1.5.5
Transferring data (drive to SD card)
You can transfer the parameter set from the drive to an SD card with the BOP. To do this, proceed as follows:
Note
Dat
a transfer between the drive and the SD card is possible only when the drive is in "S OFF" state.
Note
Plugging or unplugging the SD card will cause transferring failure.
Do not plug or unplug the SD card during transferring; otherwise, the transferring
operation will fail.
Note
Write protection function is not supported by the SINAMICS V70. Data in the SD card will be overwritten even if the write
protection function of the SD card is enabled.
A.1.5.6
Transferring data (SD card to drive)
You can also transfer the parameter set from an SD card to the drive. To do this, proceed as follows:
Note
Data
transfer between the drive and the SD card is possible only when the drive is in "S OFF" state.
Note
Plugging or unplugging the SD card will cause transferring failure.
Do not plug or unplug the SD card during transferring; otherwise, the transferring o
peration will fail.
Note
Parameter inconsistency
If the parameters on the SD card are inconsistent with existing parameters in the drive
memory, you must
save and restart the servo drive to apply the changes.