Commissioning Manual
262 6FC5397-4EP10-0BA8, 07/2018
Calling the created user cycle
After you transfer all the files necessary for your own cycle to the control system, the cycle is created successfully. Then you
can call the cycle in the program editing operating area.
Proceed as follows to call the created cycle, for example, CYCLE100.
Select the program management operating area.
Select the desired part program and press this key to open it in the pro
gram editor.
Then you can see the softkey you define at the fifth horizontal softkey, for exam
ple:
Press this softkey to open the lower
-level menu for calling user cycles, for example:
To Next Page
Loading...
