Siemens SINUMERIK 808D ADVANCED Series

Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
427
Handwheel
direction of
rotation
inverted
1004
Axis 2 in Work
Traversing keys
Rapid trav-
ers override
Traversing
key disable
Feedrate
stop
Activate handwheel (bit/binary coded)
Plus
Minus
2
1
1005
Axis 2 in Work
Machine function
2)
Continuous
traversing
Var. INC 10000 INC 1000 INC 100 INC 10 INC 1 INC
1006
1007
Invert
handwheel
direction
1008
Axis 3 in Work
Traversing keys
Rapid trav-
erse over-
ride
Traversing
key disable
Feedrate
stop
Activate handwheel (bit/binary coded)
Plus
Minus
2
1
1009
Axis 3 in Work
Machine function
2)
Continuous
traversing
Var. INC 10000 INC 1000 INC 100 INC 10 INC 1 INC
1010
1011 Invert
handwheel
direction
1)
The handwheel number is represented according to the $MD_HANDWH_VDI_REPRESENTATION machine data in a
bit-coded (=0) or binary-coded (=1) manner.
2)
Machine function: the machine function is only entered if the "INC inputs in the operating-mode signal range active"
signal (DB2600.DBX1.0) is not set.
17.9.2
Signals from NC channel
Status signals from NC channel
DB3300
Signals from NCK channel [r]
NCK → PLC interface
Byte
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
0 Last action
block active
M0/M1
active
Approach
block active
Action
block active
Forwards
traverse
active
Backwards
traverse
active
Execution
from exter-
nal active
1 program
test active
M2/M30
active
Block
search
active
Handwheel
override
active
Rev. feder-
ate active
Referenc-
ing active
2
3
Channel status
Program status
Reset
Interrupted
Active
Aborted
Interrupted
Stopped
Waiting
Running
4 NCK alarm
with pro-
cessing
stop pre-
sent
Channel
specific
NCK alarm
is active
Channel
operational
All axes
Stop re-
quest
Start re-
quest
Stationary Referenced