Commissioning Manual
52 6FC5397-4EP10-0BA8, 07/2018
Note
All vertical MCP versions have the same outline dimensions. The illustration below uses the va
riant with an override switch
for the spindle as an example.
Cut-out dimensions and mounting clearance
Note
Make sure there is enough space around the PPU and
the MCP for tightening the screws in the control cabinet.
Horizontal PPU and MCP (unit: mm)
Note
The illustration below uses PPU161.3 and the horizontal MCP with a reserved slot for the handwheel as an example.
All horizontal PPU/MCP versions share the
same requirements for cut-out dimensions and mounting clearance.
To Next Page
Loading...
