Description of the software
6.4 Description of the menu commands
Modular Safety System 3RK3
106 System Manual, 10/2008, 926 2530-02 DS 02
6.4.2 Edit menu
6.4.2.1 Undo
The menu command "Edit" > "Undo" performs the following actions:
● You can undo changes to parameters and changes in the logic diagram (moving blocks,
changing connections, etc.).
Position changes (e.g. dialog selection, scroll, select) cannot be undone.
● Once you have executed this menu command, the system displays the view that was
active before the action you have just undone.
● File functions (e.g. "Save", "Load", "Download", "Open online") delete the entire undo
history ("Undo" can no longer be used).
6.4.2.2 Redo
The menu command "Edit" > "Redo" cancels one (or more) previous undo actions.
6.4.2.3 Cut
The menu command "Edit" > "Cut" transfers selected objects to the clipboard which can then
be pasted using the "Edit" > "Paste" menu command. The selected objects are deleted from
the source file.
6.4.2.4 Copy
The menu command "Edit" > "Copy" transfers selected objects to the clipboard which can
then be pasted using the "Edit" > "Paste" menu command.
6.4.2.5 Paste
The menu command "Edit" > "Paste" pastes objects that were copied to the clipboard by the
menu command "Edit" > "Copy".
6.4.2.6 Delete
The menu command "Edit" > "Delete" removes selected objects.
6.4.2.7 Select all
The "Edit" > "Select all" menu command selects all of the graphical objects (circuit elements,
connections, comments and reference points).
This menu command can only be selected if the logic diagram is active.
To Next Page
Loading...
