Description of the software
6.7 Functions
Modular Safety System 3RK3
204 System Manual, 10/2008, 926 2530-02 DS 02
6.7.11 Output functions
6.7.11.1 Standard output
Description
The function "Standard output" is required to switch the hardware outputs of the standard
output group.
Parameters
Parameter name Description/parameter value
Name You can enter a name for the element here.
Element number Consecutive number which is automatically assigned. You can
change the number.
Element activated When this parameter is active, the function is processed in the
safety logic.
When the parameter is deactivated, the set substitute value is
made available at the output Q.
Substitute value - Q1 "0" or "1" can be assigned to the substitute value when the
element is deactivated.
Substitute value "0" means output Q = 0
substitute value "1" means output Q = 1
General
Substitute value - Q2 -
Monitoring - Parameters - Feedback
circuit
Switching time [s] -
Q1 Select the output for the processed signal.
Q2 -
Auxiliary outputs Select whether auxiliary outputs are to be activated:
• No
• One auxiliary output
• Two auxiliary outputs
AUX1 Select the output for the processed signal. The auxiliary output
AUX1 supplies the same signal as Q. It can be switched with safe
or standard modules.
AUX2 Only available when two auxiliary outputs are activated:
Select the output for the processed signal. The auxiliary output
AUX2 supplies the same signal as Q. It can be switched with safe
or standard modules.
Parameters - Output
circuit
FAULT -
See also
Messages for output functions (Page 268)
To Next Page
Loading...
