Siemens SIRIUS 3RK3 - Marking

Description of the software
6.5 Identification and configuration
Modular Safety System 3RK3
126 System Manual, 10/2008, 926 2530-02 DS 02
Information Meaning
Fieldbus interface Information on the fieldbus interface (e.g. "PROFIBUS DP") supported
by the safety relay.
This field is gray in offline mode.
System interface Information on the internal system interface supported by the safety
relay.
This field is gray in offline mode.
Device interface Information on the local interface supported by the safety relay.
This field is gray in offline mode.
ID no. Specifies the communication ID number of the safety relay.
This field is gray in offline mode.
HW revision level: Product version which is entered prior to delivery.
This field is gray in offline mode.
FW revision level Information on the version of the device firmware.
This field is gray in offline mode.
Revision counter Labels changes of HW-related parameters and cannot be edited.
This field is gray in offline mode.
I&M version Version of the I&M (Identification & Maintenance) function in the safety
relay.
This field is gray in offline mode.
Supported I&M data Specify which I&M blocks are supported by the safety relay.
This field is gray in offline mode.
Serial number Contains a production label with production information.
This field is gray in offline mode.
Time stamp The time stamp is written to the safety relay when the safety relay is
named in the factory and specifies the date and time of production.
This field is gray in offline mode.
6.5.1.2 Marking
"Identification" view
In the "Identification" > "Marking" view, you can edit descriptions about the safety relay or
system.
The descriptions are part of the plant documentation. You can read from the file using the
"Switching device" > "Open" menu command or from the safety relay using the "Switching
device" > "Open online" menu command.
Information Meaning
Plant identifier The plant identifier specifies in which part of the plant a safety relay will
be installed and operated. Max length: 32 characters.
Location identifier The location identifier specifies at which location in the plant a safety
relay will be installed and operated. Max length: 22 characters.
Installation date Enter the date the safety relay was installed in the plant here. Max.
length: 16 characters.