Description of the hardware
5.2 Mounting/installing/attaching
Modular Safety System 3RK3
64 System Manual, 10/2008, 926 2530-02 DS 02
5.2 Mounting/installing/attaching
5.2.1 Mounting the central unit, expansion module, or interface module on a DIN rail
Requirements
● At the installation location, a horizontal 35 mm mounting rail in accordance with
DIN EN 60715 is properly secured
● Please observe the information about the mounting position in section
General technical
data (Page
289).
DIN rail mounting procedure
Step Operating instruction Figure
1 Hang the back of the device onto the upper edge
of the DIN rail
2 Press the lower half of the device against the DIN
rail until the device engages
5.2.2 Mounting the central unit, expansion module, or interface module on a level
surface
Requirements
Please note the following requirements for mounting on a level surface:
● Please observe the information about the mounting position in section
Technical data
(Page
289).
● Two properly executed drill holes with thread or plug on the level surface
For the distances between the drill holes please refer to the relevant dimension drawings
in the appendix
Dimension drawings (Page 301).
To Next Page
Loading...
