Siemens SIRIUS 3RK3 - Restoring Factory Settings

Diagnostics / service
8.6 Restoring factory settings
Modular Safety System 3RK3
284 System Manual, 10/2008, 926 2530-02 DS 02
8.6 Restoring factory settings
Factory setting
To restore the factory settings of the safety relay, proceed as follows:
1. Switch the 24 V DC power supply off.
2. Hold down the "RESET" key.
3. Switch the 24 V DC power supply on again.
4. Release the "RESET" key only when the DEVICE LED flickers yellow.
5. Keep holding down the "RESET" key if the DEVICE LED flickers red.
6. Release the "RESET" key when the DEVICE LED flickers yellow.
7. Keep holding down the "RESET" key if the DEVICE LED flickers red.
8. When the DEVICE LED goes out, release the "RESET" key within 10 s.
The DEVICE LED starts to flash yellow.
Once the factory settings have been restored, the central unit automatically reboots and
switches to configuring mode (⑨, ⑩).

3UHVV
)OLFNHULQJUHG
)OLFNHULQJUHG )OLFNHULQJUHG
)OLFNHULQJ\HOORZ )OLFNHULQJ\HOORZ )ODVKLQJ\HOORZ
3UHVV 3UHVV
9ROWDJH
5(6(7EXWWRQ
'(9,&(/('
6WHSQR
Figure 8-3 Factory setting
Result
When the factory settings are restored, all the LEDs on the inputs and outputs light up.
The procedure for restoring the factory settings has the following effects: