Siemens SIRIUS 3RK3 - Commands

Description of the software
6.4 Description of the menu commands
Modular Safety System 3RK3
116 System Manual, 10/2008, 926 2530-02 DS 02
6.4.3.10 Commands...
Activate device commands
Using the "Target system" > "Commands" menu command, you can activate additional
functions on the safety relay.
1. Select a command from the drop down list in the dialog box.
2. Send it to the safety relay via the "Send" button.
You can start another command once the previous command is executed and the "Send"
button is active again.
Observe the current status
A list in the "Commands" dialog box shows the current status of the command processing
and the feedback messages from the diagnostics data memory determined by the MSS ES
safety relay. The list is expanded with each sent command. It is deleted when the dialog box
is closed.
Device commands
The following device commands are available:
Device
commands
Description Can be activated in Feedback
Factory settings All of the parameter values are reset to
their default values.
After the factory settings have been
restored, the device executes a restart
autonomously, the connection to the
safety relay is interrupted, and the
configuration is closed.
• Configuring
mode
Factory settings restored
The restart is executed.
Reset Tripping, i.e. a shutdown due to a
protection violation, can be
acknowledged using this command. All
of the faults whose causes have been
eliminated are acknowledged together
• Configuring
mode
• Test mode
• Safety mode
Reset implemented.
Reset not possible.
Restart Causes a "HW reset" of the safety relay.
• Configuring
mode
• Test mode
• Safety mode
The restart is carried out.