Description of the software
6.4 Description of the menu commands
Modular Safety System 3RK3
108 System Manual, 10/2008, 926 2530-02 DS 02
6.4.2.12 Redraw partial connection
The "Edit" > "Redraw partial connection" menu command undoes the "Interrupt connection"
command. The connecting line reappears.
This menu command can only be selected if the logic diagram is active and an interrupted
connection is selected.
6.4.2.13 Add diagram
Using the "Edit" > "Add diagram" menu command, you can insert another diagram for your
safety logic.
This menu command can only be selected if the logic diagram is active and the "Online"
connection to the safety relay is not available.
6.4.2.14 Remove diagram
The "Edit" > "Remove diagram" menu command deletes the current diagram from the
navigation window.
This menu command can only be selected if the logic diagram is active.
Note
It is only possible to split up the safety logic in connection with an offline project.
If you have not created an offline configuration for a safety relay that is configured online,
you can read the configuration from the safety relay and create a diagram using "Switching
device > Open online" or "Download to PC". This automatically positions all of the functions
in the diagram.
NOTICE
Remove diagram
If you delete a diagram, all of the connections, functions and comments will also be deleted
with it.
6.4.2.15 Edit terminal identifier...
The "Edit" > "Edit terminal identifier" menu command opens a dialog window for entering the
identifiers for the terminals.
The result only appears in the logic diagram when the relevant checkbox on the "Logic" tab
under "Options" > "Settings of Modular Safety System ES" is selected.
This menu command can only be selected if a module is selected in the main system.
To Next Page
Loading...
