Siemens SIRIUS 3RK3 - DP Interface Menu Navigation; Menu Mode with User Control

Operator control
7.5 Integrating the Modular Safety System 3RK3 in DP master systems
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
227
If you do not press any buttons for 30 seconds, the display automatically returns to the
error with the highest priority.
● Menu mode with user control
In menu mode, a menu system can be used to call up or change different settings. To
switch from standard mode to menu mode, choose "SET". The system returns to
standard mode when you choose the relevant menu option or after an extended period of
inactivity (30 s).
7.5.2.1 DP interface menu navigation
The menu navigation tree is displayed below:
.H\
3UHVVLQJ6(7
3UHVVLQJ02'(
352),%86DGGUHVV
(GLWDEOHILJXUHV
%ODQNVSDFHV
5HWXUQWRVWDWXV
PRGH
5HWXUQWRVWDWXV
PRGH
5HVWRUH
IDFWRU\VHWWLQJ
MENU
DP •••
MENU
RST••
MENU
EXIT•
DP ••
ADR••
DP ••
••x X X
DP ••
••X x X
DP ••
••X X x
XXX•
OK•••
DP ••
EXIT•
ADR•
LOCK•
RST•
EXIT•
RST•
D O •••
RST•
LOCK•
XXX
x
•
7.5.2.2 Menu mode with user control
In menu mode, the title of each menu appears in the first line on the display.
The second line may contain a menu entry or a parameter providing information about the
type of error. If this line is flashing, you can call up additional options by choosing "MODE".
When you press "SET", this either confirms a selection or executes an action.
When you press "MODE" and "SET" at the same time, the entry "EXIT" is always selected
and the current action is interrupted. You then have to release both buttons and confirm with
"SET".
When you double-click "MODE", the previous entry is selected.
If you do not press any buttons for 30 seconds, the display automatically switches to
standard mode with status display.