Operator control
7.5 Integrating the Modular Safety System 3RK3 in DP master systems
Modular Safety System 3RK3
228 System Manual, 10/2008, 926 2530-02 DS 02
Main menu
To switch from standard mode to menu mode (main menu), choose "SET". Various sub-
menus can be selected in the main menu. To switch between the various sub-menus,
choose "MODE". To confirm a selection, choose "SET".
Display
MENU
DP•••
1. row: not flashing
2nd row: flashing
The following sub-menus are available (2nd row in the display):
● DP (change the PROFIBUS address)
● RST (restore factory settings)
● EXIT (exit)
To switch between the sub-menus, choose "MODE".
When you confirm "EXIT" with "SET", the system switches to standard mode.
When you confirm the other entries with "SET", the system switches to the relevant sub-
menu.
DP sub-menu
This menu option is used to change the PROFIBUS address.
Display
MENU
DP•••
1. row: not flashing
2nd row: flashing
The following sub-menus are available (2nd row in the display):
● "ADR" (change address)
● "EXIT" (exit)
To switch between the sub-menus, choose "MODE".
When you confirm "EXIT" with "SET", the system switches to standard mode.
When you confirm "ADR" with "SET", the system switches to the sub-menu.
Changing the DP address
Note
Only addresses 1 to 126 can be set. Other addresses are not possible.
Display
DP••
ADR••
1. row: not flashing
2nd row: flashing
When you press "SET", the system switches to the editing screen 1:
To Next Page
Loading...
