Operator control
7.4 Operation with MSS ES
Modular Safety System 3RK3
222 System Manual, 10/2008, 926 2530-02 DS 02
7.4 Operation with MSS ES
7.4.1 Comparison function
MSS ES provides a function for comparing two configurations. The configuration that is
currently open in MSS ES (source configuration) is compared to a configuration to be
defined by you. This can either be online in the safety relay or offline in an sdp file.
You can call up the comparison function with the following menu commands:
● "Edit" > "Compare with switching device"
● "Edit" > "Compare with file"
The "Comparison of configurations" dialog box displays the results.
Compare with switching device
Requirement: You must load the first configuration.
Carry out the comparison as follows:
1. Open the first configuration.
2. Select the "Edit" > "Compare with switching device" menu command. The "Compare with
switching device" dialog box appears.
3. Select the safety relay that you would like to compare with the open configuration.
4. Click on the "OK" button.
Result: The source configuration is compared with the configuration in the safety relay.
Compare with file
Requirement: You must load the first configuration.
Carry out the comparison as follows:
1. Open the first configuration.
2. Select the "Edit" > "Compare with file" menu command. The "Compare with file" dialog
box appears.
3. Select the file that you would like to compare with the open configuration.
4. Click on the "Open" button.
Result: The source configuration is compared with the configuration in the sdp file.
To Next Page
Loading...
