Description of the software
6.6 Logic diagram
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
143
Use the menu command "Edit" > "Realign graphic" to arrange the objects in succession
according to the signal flow.
Note
Following the command "Realign graphic", comments are always moved below the logic.
Types of conflict
The following types of conflict are shown in the figure below:
● Part of a connection line is on top of another connection line
● Part of a block is on top of another block
● Connection lines cross over blocks
● Blocks on top of page margins
Note
Please note the following:
• Graphical conflicts can also occur at reference points.
• During graphical configuration, it is continuously checked whether graphical conflicts
occur.
• During the consistency check, graphical conflicts are listed as warning messages in the
output window.
6.6.4.6 Realign graphic
Use the menu command "Edit" > "Realign graphic" to arrange the functions and connections
according to the signal flow.
Call:
Button Command
"Edit" > "Realign graphic"
To Next Page
Loading...
