Description of the software
6.5 Identification and configuration
Modular Safety System 3RK3
132 System Manual, 10/2008, 926 2530-02 DS 02
Open the "Central unit properties" dialog
You can open the dialog window "Central unit properties" as follows:
● Double-click on a module in the configuration table.
● Select the menu option "Object properties" of the context menu (right mouse button).
● In the menu "Options" > "Settings of Modular Safety System ES" under the tab "General
settings", activate the checkbox "Display object properties automatically on insert". The
properties dialog window will then pop up automatically when you drag a module from the
catalog window into the configuration table of the project window.
The parameters are described in the following table:
Parameter name Parameter value
Configuration
Module The designation of the selected module is displayed here. The field has a gray background
and cannot be changed by the user.
Order No. The order number of the selected module is shown here. The field has a gray background and
cannot be changed by the user.
Firmware The firmware of the selected module is shown here. The field has a gray background and
cannot be changed by the user.
Equipment identifier Here you can specify a user-defined equipment identifier (max. 32 characters) for the selected
module and assign it to inputs and outputs.
Inputs The maximum number of available inputs is indicated here.
Outputs The maximum number of available outputs is indicated here.
Parameter assignment - Device response
Program cycle time [ms] Here you define the program cycle time within a range of 10 to 60 ms in increments of 5 ms.
6.5.2.4 Properties of interface modules
Description
You can open the dialog window "Properties of interface modules" as follows:
● Double-click on a module in the configuration table.
● Select the menu option "Object properties" of the context menu (right mouse button).
● In the menu "Options" > "Settings of Modular Safety System ES" under the tab "General
settings", activate the checkbox "Display object properties automatically on insert". The
properties dialog window will then pop up automatically when you drag a module from the
catalog window into the configuration table of the project window.
In this dialog window, the following parameters are shown:
● In online mode: The parameters of the uploaded module.
● Editable parameters
To Next Page
Loading...
