Description of the hardware
5.2 Mounting/installing/attaching
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
65
● Two screws with a maximum thread diameter of 4.8 mm
● Two plastic securing brackets
Please refer to the accessories list for the relevant order numer in section
System
components (Page
23)
Procedure for mounting on a level surface
Step Operating instruction Figure
1 Insert the securing brackets into the openings
provided on the device until they engage.
2 Hold the device up to the surface prepared for
screw fastening.
3 Insert the screws through the oblong holes in the
securing brackets.
4 Screw the device onto the level surface so that it
is secure.
5.2.3 Installing the diagnostics module in a control cabinet door/switchboard
Requirements
● A mounting cut-out measuring H x W 55 x 92 mm must be available.
● The control cabinet door/control panel must be no more than 16 mm thick.
NOTICE
Overall depth
Please observe the installation depth of 41 mm for the device.
To Next Page
Loading...
