Siemens SIRIUS 3RK3 - Data Set 92

Diagnostics / service
8.5 Diagnostics with data sets
Modular Safety System 3RK3
278 System Manual, 10/2008, 926 2530-02 DS 02
8.5.5 Data set 92
All device-specific messages and information about the individual device function statuses
are collected centrally and stored in the 3RK3 Basic message memory. The message
memory can be read via DS92. The current device status is stored as of byte 12.
The content of DS92 is described below:
DS92 (device messages)
Byte Message bit Error
category
DP error
no.
Comments
NST2000 header:
0…11 Reserved=0
Device status:
12
0
Device error (GF / DEVICE) GF F9 Device defective
12
1
Group error (SF) SF F24 Min. 1 group error present
12
2
Bus error (BF) BF F19 Min. 1 bus error present
12
3
Group warning (SW) SW F23 At least one warning pending
12
4
Reserved=0
12
5
Reserved=0
12
6
Reserved=0
12
7
Reserved=0
13
0
Reserved=0
13
1
Error in configuration SF F24, F27 TARGET <> ACTUAL configuration
Switch to configuring mode
13
2
Configuring error SF F24, F27 The configuration contains at least 1
error
13
3
Reserved=0
13
4
Wiring fault SF F24, F26 A wiring fault is present
13
5
Logic error SF F24, F25 A logic error is present (e.g. discrepancy
or sequence violation)
13
6
Reserved=0
13
7
Reserved=0
14
0
Configuring mode active Device is in configuring mode
14
1
Test mode active Device is in test mode
14
2
Safety mode active Device is in safety mode
14
3
User program is active Device is in test or safety mode.
The safety program is executed.
14
4
User program stopped. The safety program is executed.
14
5
Reserved=0
14
6
Reserved=0
14
7
Operating mode change rejected The operating status could not be
changed
15
0
Access path closed An access path in the device is not open.
15
1
Access path to fieldbus control is
open
Access path via the fieldbus interface is
open.
15
2
Reserved=0