Description of the software
6.5 Identification and configuration
Modular Safety System 3RK3
128 System Manual, 10/2008, 926 2530-02 DS 02
● With the menu command "Edit" > "Check consistency"
● When a configuration is saved
● With the menu command "Target system" > "Prepare configuration test..."
The messages are displayed in the output window. By clicking on a message in the output
window, you can jump to the corresponding error location.
The following messages may appear during the consistency check:
Message Type Message text Remedy
Name of configuration
engineer is missing
Error "General configuration: Name of
configuration engineer is missing."
Enter the name of the configuration
engineer in the "Project" parameter
assignment view
Name of the the
configuration engineer's
company is missing
Error "General configuration: Name of
configuration engineer's company is
missing."
Enter the name of the company of the
configuration engineer in the "Project"
parameter assignment view
Project name is missing Error "General configuration: Project name
is missing."
Enter the project name in the "Project"
parameter assignment view
The memory module is full Error "General configuration: The memory
of the memory module is full. Reduce
the plant documentation or optimize
the logic (if applicable).
Reduce the memory requirements on
the memory module
To Next Page
Loading...
