Description of the software
6.6 Logic diagram
Modular Safety System 3RK3
140 System Manual, 10/2008, 926 2530-02 DS 02
Drawing a connection between functions
To interconnect connections of functions, execute the following steps:
Step Description
1 Move the mouse pointer over an unconnected input. It is then highlighted in blue.
2 Press the left mouse button and keep it pressed.
Keep the mouse button pressed and draw a connection to an output until it is highlighted in blue.
3 Release the mouse button.
Result:
A connection between the two terminals is established.
Note:
You can also draw the connection from the output to the input.
Connections between functions in different diagrams
To connect functions in different diagrams, proceed as follows:
Step Description
1 Select the connection point of the function in the first diagram.
2 In the context menu (right mouse button), select the command "Begin drawing connection".
3 Switch to the second diagram.
4 Select the connection point of the second function.
5 In the context menu (right mouse button), select the command "Finish drawing connection".
Crossover points of connections
● Crossover points of connections are not specifically marked. The route of the lines is
usually apparent.
● If due to the high number of connections the route of the lines is not immediately
apparent, then select the connection and its exact route will be highlighted.
To Next Page
Loading...
