Getting Started
4.8 MSS function test
Modular Safety System 3RK3
40 System Manual, 10/2008, 926 2530-02 DS 02
Configuration release
Step Action Result
1 Select the menu command "Target system" > "Go
offline".
The offline configuration is opened.
2 Choose "Target system" > "Approve configuration". The "Approve configuration" dialog box is opened,
thereby confirming that the configuration test has been
performed properly.
3 Set the interface via which you have access to the
device (e.g. COM1) and confirm with "OK".
The "Approve configuration" dialog box opens.
4 Enter the name and approving company and confirm
with "OK".
The "Approve configuration" dialog box opens. The
configuration has been successfully approved.
5 Acknowledge the message with "OK". The printout of the release information is created.
Note
If the report could not be printed when the project was released, e.g. no printer or software
(Adobe Reader), the printout must be created at the latest at the approval stage by selecting
"Options" > "Release information...".
Safety mode
Step Action Result
1 Establish an online connection with the MSS via the
menu command "Switching device" > "Open online" or
"Target system" > "Load to PC".
The Set interface dialog box appears.
2 Set the interface and confirm with "OK". The project opens online.
3 Activate the menu command "Target system" > "Safety
mode".
The message "Activate safety mode" appears.
4 Confirm with "Yes". The MSS changes to safety mode without password
protection.
To Next Page
Loading...
