Description of the hardware
5.2 Mounting/installing/attaching
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
67
Removing the central unit, expansion module, or interface module from a DIN rail
Step Operating instruction Figure
1 Pull the device down until the lower half
can be pulled away from the DIN rail.
2 Pull the lower half of the device away
from the DIN rail.
3 Lift the device from the upper edge of
the DIN rail.
Removing the central unit, expansion module, or interface module from a level surface
Step Operating instruction Figure
1 Hold the device firmly.
2 Unscrew the cap screws.
3 Lift the device from the level surface.
4 Remove the securing brackets from the
device.
To Next Page
Loading...
