Mounting / connection
4.2 Connection
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
109
The brake output for the M200D motor starter
The brake voltage is fed to the motor together with the motor infeed via a joint cable
(e.g. 6 x 1.5 mm
2
).
Hazardous Voltage
Can Cause Death or Serious Injury.
The brake is only switched in a single phase. This therefore means that voltage can be
applied at pin 6 even when the system is switched off.
To Next Page
Loading...
