Product family
2.3 Design concept
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
21
The motor starter is equipped with the following operator controls:
Key-operated switch (order variant)
Keypad (order variant manual local control)
Disconnecting means (circuit breaker)
Setting elements on PROFIBUS communication module
Integrated manual local control (key-operated switch ① and keypad ②; order variant)
A key-operated switch and keypad are used for local operation.
The key can be inserted/removed in three positions.
Disconnecting means ③ (circuit breaker)
The disconnecting means is designed for the following individual functions:
● Disconnecting the series-connected loads from the line voltage
● Short-circuit protection of the series-connected load
● Switching on inhibited via padlock (max. three padlocks possible)
Parameter settings on PROFIBUS ④
The following setting elements are located under the cover:
● Bus terminating resistor
● DIP switch for setting the PROFIBUS DP address
To Next Page
Loading...
