Siemens SIRIUS M200D - Brake Output

Mounting / connection
4.2 Connection
M200D PROFIBUS/PROFINET
108 Manual, 08/2014, A5E01577426A/RS-AA/004
Brake variants
400 V AC
230 V AC
180 V DC
Note
Please note the different pin assignment in the case of the operating voltages of the brake.
4.2.6
Brake output
M200D motor starters can be equipped with an optional electronic brake control (order
variant). The brake control is suitable for externally-suppled brakes with the coil voltages
shown below:
● 400 V AC / 230 V
The brake rectifier must be installed in the motor. The rectifier input is controlled via the
motor starter.
● 180 V DC
A rectifier is not required for the brake in the motor because the 180 V DC is provided by
the motor starter. In this way, brake coils for 180 V DC can be switched directly.