Mounting / connection
4.2 Connection
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
111
Digital outputs OUT1, OUT2
The motor starter is equipped with two digital outputs that you can connect direct to an
actuator.
The outputs can be loaded to max. 0.5 A and protected electronically against short circuits.
A connector (M12, 4 or 5 pin) is used for establishing the connection. The motor starter is
equipped with a range of sockets.
Example: Connecting the digital output
To Next Page
Loading...
