Mounting / connection
4.2 Connection
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
115
You connect the supply voltage and PROFINET IO at the M200D PROFINET
communication module. The communication module is equipped with a PROFINET switch
This allows direct looping through of PROFINET IO, or the direct connection of a further IO
device.
Figure 4-8 PROFINET IO communication module
-X33
24V DC
7/8" circular socket connector (with pin insert) for infeed of the DC 24V-NS
electronic/encoder supply and the DC 24V-S load voltage supply
-X34
24V DC
7/8" circular socket connector (with socket insert) for looping through the
DC 24V-NS electronic/encoder supply and the DC 24V-S load voltage supply
-X31
P1
M12 circular socket connector (with socket insert) for connection of PROFINET IO
-X32
P2
M12 circular socket connector (with socket insert) for connection of PROFINET IO
Modules with PROFINET interfaces may only be operated in LANs (Local Area Network) in
which all nodes are equipped with SELV / PELV power supplies or protection systems of
equal quality.
A data transfer terminal (modem, for example) is required to access the WAN (Wide Area
Network) in order to ensure compliance with this safety standard.
To Next Page
Loading...
