Siemens SIRIUS M200D - Outputs

Functions
3.7 System monitoring
M200D PROFIBUS/PROFINET
60 Manual, 08/2014, A5E01577426A/RS-AA/004
Messages and actions
Message
Action
Input 1 Dependent on parameterization
Input 2 Dependent on parameterization
Input 3 Dependent on parameterization
Input 4 Dependent on parameterization
Input tripping Trip
Input tripping - end position CW rotation Tripping
(must be acknowledged with Motor OFF)
Input tripping - end position CCW rotation
Input control The motor is controlled via the inputs
Input warning The motor is controlled via the inputs
Sensor supply overload Tripping
(must be acknowledged with trip reset)
The signal states of all inputs are undefined in the
event of a "sensor overload".
Quick stop active Trip
3.7.4
Outputs
Description
The motor starter can use the "outputs" function to control various actuators (e.g. indicator
lights or signalling auxiliary switches). Control can take place here from different control
sources. Different functions and information can be parameterized for each of the outputs.
The digital outputs are overload-protected and short-circuit-proof and are supplied from the
DC24V-S load voltage supply.
Output n level
With this device parameter, you determine whether the control signal of the output is inverted
or not dependent on the set parameter.
Output n signal
With this device parameter, you determine how the signal is to be output:
● Continuous signal
● Flashing
Output n action
Different parameterizable actions can be triggered when an output signal is present.