Mounting / connection
4.1 Mounting
M200D PROFIBUS/PROFINET
96 Manual, 08/2014, A5E01577426A/RS-AA/004
Installing the protection guards
Protection guard (accessory)
The protection guards are designed for a maximum load of 10 kg.
To prevent mechanical damage to the motor starter cables and connections, you can install
protection guards on the side and top (order no.: 3RK1911-3BA00).
To secure the protection guards, the angled ends can be used as clamping bolts, which are
secured in the device base by means of eccentric elements.
①
Insert the eccentric elements in the locating holes on the bottom of the motor starter.
Make sure that the holes are aligned for the protection guards.
②
Push the ends of the protection guards into the holder until they engage.
③
Turn the eccentric elements clockwise until the protection guard is secure.
To Next Page
Loading...
