Siemens SIRIUS M200D - DS72 Logbook - Read Device Error

Appendix
A.1 Data formats and data sets
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
197
A.1.6
DS72 logbook - Read device error
Byte
Data type
Meaning
Range of values
Increment
Entry 1 (= latest entry)
0 ... 3 Unsigned 32 Operating hours device 0 ... 4 294 967 295 1 s
4 ... 5 Unsigned 16 Object number 0 ... 32767 1
Entry 2
6 ... 9 Unsigned 32 Operating hours - device 0 ... 4 294 967 295 1 s
10 ... 11 Unsigned 16 Object number 0 ... 32767 1
...
...
Entry 21
120 ... 123 Unsigned 32 Operating hours - device 0 ... 4 294 967 295 1 s
124 ... 125 Unsigned 16 Object number 0 ... 32767 1
The data record call "Logbook" returns the operating hour of the event that has occurred and
an associated object number for each entry. This data set can accommodate 21 entries.
When all locations have been overwritten, the oldest entry is overwritten again.
Note
The latest entry is entered at the first location of the data set. The remaining entries are
moved one entry down.
The supported object numbers and their meaning are shown in the table below:
Table A- 3 Assignment of object number to device error message
Object No.
Device error - Messages
451 Temperature sensor not ready for operation
452 Heat sink thermistor defective
453 Faulty interface to current detection
454 Faulty SSC interface
456 EEPROM: memory defective
457 EEPROM: CRC error "Fixed-value parameter"
458 EEPROM: CRC error "Device parameter"
460 EEPROM: contains invalid data!
461 EEPROM: Invalid value for "Parameters disabled CPU/master"
462 EEPROM: Invalid pointer for device parameter buffer
308 Switching element defective
1414 Switching element short-circuited
483 HMI module defective